Lecture Notes on Standard Components Used in Jigs and Fixtures
A PDF version of a book prepared on the standard components used in jigs and fixtures.
Lecture Notes Contents
Two-view and 3D perspective drawings and dimensioning of the components used in jigs and fixtures
Handle bolt
Knurled-head bolt
Wing-head bolt
Pin-handle bolt
Stud
Locking bolt
Hinged bolt
Jack screw and nut
Spherical-seat nut
Knurled nut
Wing nut
Finger nut
Wrench nut
Finger nuts
Quick-acting nuts
T-nut
Washer
Spherical washer
C-washer
Hinged C-washer
Z-clamp
Cylindrical-tip clamp
Swivel clamp / Double-end clamp
Straight-line-motion clamp
Straight-line-motion clamp
Rear-actuated clamp
Jaw clamp
Cam
Longitudinal-motion clamp
Cylindrical clamps
Clamp rotating about an axis
Eccentric stop
Locating plate
V-block
Dowel pin
Locating pin
Index pin and bushing
Fork
Seating surface – Support
Spring-loaded support
Adjustable support
Standard Components Used in Jigs and Fixtures PDF
Jigs and Fixtures standard components PDF file (Turkish document)
CLICK HERE TO DOWNLOAD
Standard Guide Posts
The guide posts and bushings used in jigs and fixtures ensure precise alignment between the upper and lower halves of the die.
Use of Standard Springs
The compression springs used in dies ensure that stripper plates and ejectors move with the correct force.
Time and Cost Savings
Using standard die components significantly reduces die construction time and cost compared to custom-made parts.
Related Questions
Guide posts, bushings, and compression springs are among the standard components used in jigs and fixtures.
Guide posts and bushings ensure precise alignment between the upper and lower halves of the die.
Using standard die components significantly reduces die construction time and cost compared to custom-made parts.
Related Posts
Trimming (Correction) Amount in Drawing Dies 
Press Operator Training Notes 
What Is a Pantograph? How Does It Work? 
Preventing Wrinkling and Determining Draw Stages in Drawing Dies 
Progressive Dies 
Washer Die Assembly and Detail Drawings – Dwg pdf 
Die Guide Pillars and Bushings 
Standard Die Shanks and Their Dimensions